The maintenance cycle of automatic stuffing machine is usually recommended to be a comprehensive inspection every six months to one year. This cycle is mainly determined by the frequency of use, maintenance and quality of the equipment. The higher the frequency of use, the greater the degree of wear, and the maintenance cycle may be shortened accordingly; the wear rate of internal parts of equipment that is regularly maintained and cleaned will slow down, thereby extending the maintenance cycle; high-quality equipment pays more attention to durability during the design and manufacturing process, and the maintenance cycle is relatively long.
Maintenance points
Cleaning: After each use, the residue on the surface of the equipment should be cleaned in time, and the dust and oil inside the equipment should be cleaned regularly.
Lubrication: The transmission system and bearings of the bun machine need to be lubricated regularly to reduce friction and wear.
Tightening: Regularly check the tightness of each component of the equipment. If looseness is found, it should be tightened in time to avoid vibration and noise caused by looseness.
Protection: Pay attention to the protection of the electrical system of the equipment, prevent water, oil and other liquids from entering the electrical components, and take dust and moisture-proof measures.
Specific maintenance steps and precautions
Cleaning: Remove the scraps or dirt inside the equipment to ensure that the inside of the equipment is clean.
Lubrication: Regularly add an appropriate amount of lubricating oil or cooking oil to the transmission system and bearings.
Tightening: Check and tighten each part of the equipment to ensure that there is no looseness.
Protection: Pay attention to the electrical system protection of the equipment to prevent liquid from entering the electrical components, and take dust and moisture-proof measures.
